Cross-section measurement of the 130^{130}Ba(p,γ\gamma)131^{131}La reaction for γ\gamma-process nucleosynthesis

Sep 25, 2014
7 pages
Published in:
  • Phys.Rev.C 90 (2014) 3, 035806
  • Published: Sep 25, 2014
e-Print:

Citations per year

201520172019202120234210
Abstract: (APS)

Background: Deviations between experimental data of charged-particle-induced reactions and calculations within the statistical model are frequently found. An extended data base is needed to address the uncertainties regarding the nuclear-physics input parameters in order to understand the nucleosynthesis of the neutron-deficient p nuclei.

Purpose: A measurement of total cross-section values of the Ba130(p,γ)La131 reaction at low proton energies allows a stringent test of statistical model predictions with different proton+nucleus optical model potentials. Since no experimental data are available for proton-capture reactions in this mass region around A 130, this measurement can be an important input to test the global applicability of proton+nucleus optical model potentials.

Method: The total reaction cross-section values were measured by means of the activation method. After the irradiation with protons, the reaction yield was determined by use of γ-ray spectroscopy using two clover-type high-purity germanium detectors. In total, cross-section values for eight different proton energies could be determined in the energy range between 3.6 MeV Ep 5.0 MeV, thus, inside the astrophysically relevant energy region.

Results: The measured cross-section values were compared to Hauser-Feshbach calculations using the statistical model codes TALYS and SMARAGD with different proton+nucleus optical model potentials. With the semimicroscopic JLM proton+nucleus optical model potential used in the SMARAGD code, the absolute cross-section values are reproduced well, but the energy dependence is too steep at the lowest energies. The best description is given by a TALYS calculation using the semimicroscopic Bauge proton+nucleus optical model potential using a constant renormalization factor.

Conclusions: The statistical model calculation using the Bauge semimicroscopic proton+nucleus optical model potential deviates by a constant factor of 2.1 from the experimental data. Using this model, an experimentally supported stellar reaction rate for proton capture on the p nucleus Ba130 was calculated. At astrophysical temperatures, an increase in the stellar reaction rate of 68% compared to rates obtained from the widely used NON-SMOKER code is found. This measurement extends the scarce experimental data base for charged-particle-induced reactions, which can be helpful to derive a more globally applicable proton+nucleus optical model potential.

Note:
  • 7 pages, 6 figures
  • 25.40.Lw
  • 26.30.-k
  • 29.30.Kv
  • 24.10.Ht