CCAT: LED Mapping and Characterization of the 280 GHz TiN KID Array - INSPIRE

DataBETA

CCAT: LED Mapping and Characterization of the 280 GHz TiN KID Array

Oct 28, 2024

4 pages

Published in:

IEEE Trans.Appl.Supercond. 35 (2025) 5, 2400504

Published: Aug, 2025

e-Print:

2410.21396 [astro-ph.IM]

DOI:

10.1109/TASC.2024.3517564

View in:

ADS Abstract Service

reference search0 citations

Citations per year

0 Citations

Abstract: (IEEE)

Prime-Cam, one of the primary instruments for the Fred Young Submillimeter Telescope (FYST) developed by the CCAT Collaboration, will house up to seven instrument modules, with the first operating at 280 GHz. Each module will include three arrays of superconducting microwave kinetic inductance detectors (KIDs). The first KID array fabricated for the 280 GHz module uses titanium-nitride (TiN) as the superconducting material and has 3,456 individual detectors, while the other two arrays use aluminum. This paper presents the design and laboratory characterization of the 280 GHz TiN array, which is cooled below its critical temperature to

\sim

0.1K and read out over six RF feedlines. LED mapping, a technique for matching the measured resonant frequency of a detector to its physical position, was performed on the array so that the results can be used to lithographically trim the KID capacitors and increase the yield of the array by reducing frequency collisions. We present the methods and results of LED mapping the 280 GHz TiN KID array before deployment on FYST.

Note:

4 pages, 4 figures, submitted to IEEE Transactions on Applied Superconductivity (IEEE TAS)

Light emitting diodes
Detectors
Resonant frequency
Tin
Resonators
Frequency measurement
Telescopes
Extraterrestrial measurements
Capacitors
Astronomy

References(8)

Figures(6)

[1]

CCAT-prime Collaboration: Science Goals and Forecasts with Prime-Cam on the Fred Young Submillimeter Telescope

CCAT-Prime

Collaboration

•

Manuel Aravena

et al.

- Astrophys.J.Suppl. 264 (2023) 1, 7
•
e-Print:
- 2107.10364
•
DOI:
- 10.3847/1538-4365/ac9838

[2]

Sensitivity of the Prime-Cam Instrument on the CCAT-prime Telescope

et al.

- J.Low Temp.Phys. 199 (2020) 3-4, 1089-1097
•
e-Print:
- 1908.10451
•
DOI:
- 10.1007/s10909-020-02428-z

[3]

Prime-Cam: a first-light instrument for the CCAT-prime telescope

E.M. Vavagiakis
(
- Cornell U.
)
,
Z. Ahmed
(
- SLAC
)
,
A. Ali
(
- UC, Berkeley
)
,
K. Basu
(
- Bonn U.
)
,
N. Battaglia
(
- Cornell U. and
- Harvard-Smithsonian Ctr. Astrophys.
)

et al.

- Proc.SPIE Int.Soc.Opt.Eng. 10708 (2018) 107081U
•
e-Print:
- 1807.00058
•
DOI:
- 10.1117/12.2313868

[4]

CCAT-prime: design of the Mod-Cam receiver and 280 GHz MKID instrument module

et al.

- Proc.SPIE Int.Soc.Opt.Eng. 12190 (2022) 61
•
e-Print:
- 2208.05468
•
DOI:
- 10.1117/12.2630115

[5]

CCAT-prime: Designs and status of the first light 280 GHz MKID array and mod-cam receiver

Cody J. Duell
(
- Cornell U.
)
,
Eve M. Vavagiakis
(
- Cornell U.
)
,
Jason Austermann
(
- NIST, Boulder
)
,
Scott C. Chapman
(
- Dalhousie U. (main)
)
,
Steve K. Choi
(
- Cornell U.
)

et al.

- Proc.SPIE Int.Soc.Opt.Eng. 11453 (2020) 114531F
•
e-Print:
- 2012.10411
•
DOI:
- 10.1117/12.2562757

[6]

CCAT-prime: Characterization of the first 280 GHZ MKID array for Prime-Cam

S.K. Choi

- J.Low Temp.Phys. 209 (2022) 849-856
•
DOI:
- 10.1007/s10909-022-02787-9

[7]

An Open Source, FPGA-based LeKID readout for BLAST-TNG: Pre-flight Results

et al.

- J.Astron.Inst. 05 (2017) 04, 1641003
•
e-Print:
- 1611.05400
•
DOI:
- 10.1142/S2251171716410038

[8]

Superconducting micro-resonator arrays with ideal frequency spacing

X. Liu

•
DOI:
- 10.1063/1.5016190